McDATA 4314 Installation Guide download pdf (Page 35)

Installation

3-3

Installing a Switch

Environmental Conditions

Consider the factors that affect the climate in your facility such as equipment

heat dissipation and ventilation. The switch requires the following operating

conditions:

• Operating temperature range: 5 – 40°C (41 – 104°F)

•Relative humidity: 5 – 90%, non-condensing

Installing a Switch

Installing a McDATA 4314 switch module involves the following steps:

1. Install SFP transceivers.

2. Insert the switch module in the server chassis.

3. Connect the management workstation to the switch module.

4. Install the EFCM BASIC application.

5. Configure the switch module.

6. Cable devices to the switch module.

Install SFP Transceivers

The switch module has been validated with transceivers that support a

variety of interconnection media. To install a transceiver, insert the

transceiver into the port and gently press until it snaps in place. To remove a

transceiver, gently press the transceiver into the port to release the tension,

then pull on the release tab or lever and remove the transceiver. Different

transceiver manufacturers have different release mechanisms. Consult the

documentation for your transceiver.

NOTE: The transceiver will fit only one way. If the transceiver does not install under

gentle pressure, flip it over and try again.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 67 68

No comments

McDATA 4314 Installation Guide Page 35