McDATA 1U Server Service Manual download pdf (Page 108)

2-66

McDATA Sphereon 4400 Fabric Switch Installation and Service Manual

Installation Tasks

f. Select from the drop-down list in the Speed column to

configure the port transmission rate. Available selections are

auto-negotiate between speeds (Negotiate), 1.0625 Gbps

operation (1 Gb/sec), 2.1250 Gbps operation (2 Gb/sec), and

4.2500 Gbps operation (4 Gb/sec).

g. The NPIV feature must be installed to allow multiple Fibre

Channel addresses to be assigned to an N_Port. Refer to

Installing PFE Keys (Optional) for instructions. Type the desired

value (1 - 256) in the NPIV Login Limit column.

h. Enable the check box in the Port Binding column to enable or

disable the feature (default is disabled). A check mark

indicates binding is enabled and the port can connect only to a

device with a WWN listed in the Bound WWN column.

i. Type the WWN or nickname of the device attached to the port

in the Bound WWN column.

• If port binding is enabled and a WWN or nickname

appears in the Bound WWN column, only the specified

device can connect.

• If port binding is enabled but no WWN or nickname

appears in the Bound WWN column, no device can connect.

• If port binding is disabled, any device can connect.

2. Click Activate to save the information and close the dialog box.

Configure SNMP

Follow the procedures in this section to configure names, write

authorizations, addresses, and UDP port numbers for SNMP trap

message recipients. To configure recipient workstations:

1. Select Operating Parameters from the Configure

menu(Configure>Operating Parameters). The Operating

Parameters dialog box appears.

1. Select the SNMP tab (Figure 2-32).

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 315 316

No comments

McDATA 1U Server Service Manual Page 108