McDATA 1U Server Service Manual download pdf (Page 47)

Task 2: Unpack, Inspect, and Install the Ethernet Hub (Optional)

2-5

Installation Tasks

Task 2: Unpack, Inspect, and Install the Ethernet Hub (Optional)

This section describes how to unpack, inspect and install the theernet

hub.

The product is managed through either:

• An Internet connection to a browser-capable PC (EFCM Basic

Edition interface). Connection of a LAN segment with multiple

switches to the Internet may require installation of a 24-port

Ethernet hub.

• A 10/100 megabit per second (Mbps) LAN connection to a

management server. Connectivity may require installation of a

24-port Ethernet hub. A combination of up to 48 products can be

configured and managed on one network, therefore multiple,

daisy-chained hubs may be required to provide sufficient port

connections.

The following paragraphs provide instructions to unpack, inspect,

and install one or more Ethernet hubs.

• If the existing Ethernet LAN segment is adequate for connectivity

and a hub is not delivered, this task is not required. Go to Task 3:

Unpack, Inspect, and Install the Product.

• If the hub is delivered in a Fabricenter equipment cabinet, go to

Task 5: Configure Product Network Information (Optional).

Unpack and Inspect

Ethernet Hub

To unpack and inspect Ethernet hub(s) use the following steps:

1. Inspect shipping container(s) for damage. Ensure a freight carrier

representative is present when the container is opened. Unpack

shipping container(s) and inspect each item for damage. Ensure

that the packaged items correspond to items listed on the

enclosed bill of materials.

2. Contact the solution center if items are damaged or missing,:

Phone: (800) 752-4572 or (720) 558-3910

Fax: (720) 558-3851

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 315 316

No comments

McDATA 1U Server Service Manual Page 47